Lecn Anhui Co., Ltd

Hydraulic Plate rolls are most advance version which used in current industries because of Its features,technology and versatality of different shape making by plate bending. Where as Mechanical   rolling machines   are typically less advance but Economical solution for the small fabricator and Startup fabrication industry. Both machines are manufactured as per Different requirement of maximum plate thickness to be bent and width of that plate. Commonly 2000 mm , 2500 mm, 3000 mm width are available in the Steel plates in the market. Hydraulic Rolling machines are capable to bend more higher thickness easily compare to mechanical motorized machines. Mechanical machines are majorly used in site work, mobile fabrication plants or pipe line projects or refinery projects for maintainence purpose. Hydraulic plate rolling machine is easy to operate with less manual effort which results good productivity with minimum waste of plate ends.   Our Plate Rolling M...

Plate Rolling machine is the key member of Vessels manufacturers & Industrial Tanks Makers. Plate Rolling machine can be classified in two major types: Hydraulic type Plate roll Mechanical type Plate roll Hydraulic Plate rolls are most advance version which used in current industries because of Its features,technology and versatality of different shape making by plate bending. Where as Mechanical   rolling machines   are typically less advance but Economical solution for the small fabricator and Startup fabrication industry. Both machines are manufactured as per Different requirement of maximum plate thickness to be bent and width of that plate. Commonly 2000 mm , 2500 mm, 3000 mm width are available in the Steel plates in the market. Hydraulic Rolling machines are capable to bend more higher thickness easily compare to mechanical motorized machines. Mechanical machines are majorly used in site work, mobile fabrication plants or pipe line projects or refiner...

3 Rolling machine rolling process Obtain material The material must be confirmed in accordance with the drawings and process requirements, and the surface of the material should not have obvious defects. Material quality and specifications should comply with relevant national standards and industry standards.   Delineate the boundary When expanding, the barrel diameter must be the same as the actual diameter of the end shell, and the barrel material diameter should be calculated according to the middle diameter of the barrel. The direction of the unfolded length should be the same as that of the rolled steel, and the limit position is 45°. The alignment should be reasonable, making full use of the edge material and improving the utilization rate of steel. When welding multiple sections of the cylinder, the welding seam should be properly configured according to the technical requirements of the equipment assembly welding. End shell butt welds, cylindrical shell section longitudinal...